Hidden Trading Costs: Spread, Swap, Commission and Slippage

7 min read

A strategy can look profitable on the chart and lose money in a live account, and the most frequent cause is not the signal but the costs. Every trade pays a toll, and the shorter your stop, the bigger the share of your risk it eats. This guide breaks down the costs of trading, shows with numbers how they change your risk-reward ratio and expectancy, and explains how to measure them in your own journal.

The five costs of every trade

Execution costs fall into five groups: the spread (the difference between the buy and sell price), the commission (a fixed or proportional fee charged by the broker, common on low-spread accounts and in futures), the swap or financing (a charge or credit for holding a position overnight), the slippage (the difference between the expected price and the actual fill) and, in some cases, extras such as market data fees, currency conversion or inactivity fees.

None of them shows on your chart, which is why they are underestimated. Their sum is the total execution cost, and the really useful step is to express it in the same unit as your risk, that is, in multiples of R (the loss of a trade that hits its stop).

Spread: you pay it on the way in, not on the way out

If EUR/USD is quoted at 1.08488 bid and 1.08500 ask, the spread is 0.00012, that is, 1.2 pips. When you buy you pay the higher price and, if you close immediately, you receive the lower one: you start every trade in the red by the amount of the spread. At a 1.2-pip spread, for each standard lot (10 USD per pip) you pay 12 USD just to get in and out.

The spread is not fixed. It widens in low-liquidity hours, around major news and on exotic pairs. Compare the spread to the distance of your stop, not to the price: a 1.2-pip spread is negligible for a 100-pip stop and very significant for an 8-pip one.

Commission, swap and financing

Commission is usually charged per lot and per round trip (entry and exit). A raw-spread account with a 7 USD per lot round-trip commission adds 0.7 pips of cost on a pair worth 10 USD per pip (7 ÷ 10), so you must add it to the spread when comparing accounts: 0.2 pips of spread plus 0.7 of commission is 0.9 pips, against a “commission-free” account at 1.2 pips.

The swap depends on the interest rates of the two currencies and on the broker’s markup, and can be positive or negative depending on direction. It is applied for each night a position stays open and is usually tripled on one day of the week to cover the weekend (the day varies by instrument). As an example, with 0.20 lots and a swap of −7 USD per lot per night, holding the position for 14 calendar days costs 0.20 × 7 × 14 = 19.60 USD, which on a 100 USD risk is almost 20% of R. On index and commodity CFDs, financing is calculated differently; check your broker’s conditions.

Slippage and execution cost

Slippage is the difference between the price at which you wanted to trade and the price at which you were actually filled. It can be favorable, but with market orders and stops during volatile moments it is usually unfavorable, and on a gap at the open it can far exceed the distance to your stop. It matters most with market orders, in illiquid instruments and around news.

If your stops fill 0.5 pips worse than planned on average with an 8-pip stop, your real loss is 8.5 pips: 6% more than planned on every loser. Short-term traders should estimate slippage from real data, not intuition, because it accumulates with every trade.

Example: a scalping setup with an 8-pip stop and a 1.2-pip spread

Imagine a scalping strategy with an 8-pip stop and a 12-pip target, a nominal ratio of 1.5. With a 45% win rate, the nominal expectancy is 0.45 × 12 − 0.55 × 8 = 5.4 − 4.4 = +1.0 pips per trade. That looks like a clear edge.

Now apply a 1.2-pip spread as a cost on every trade: winners become 12 − 1.2 = 10.8 pips and losers 8 + 1.2 = 9.2 pips. The real ratio is 10.8 ÷ 9.2 = 1.17, and the expectancy is 0.45 × 10.8 − 0.55 × 9.2 = 4.86 − 5.06 = −0.2 pips. The strategy goes from earning 1.0 pip to losing 0.2 per trade, simply because the spread eats 1.2 pips each time.

How cost shifts the break-even point

Before costs, the minimum win rate to avoid losing with an 8-pip stop and a 12-pip target is 8 ÷ (8 + 12) = 40%. With the 1.2-pip cost, it rises to 9.2 ÷ (9.2 + 10.8) = 46%. Every pip you pay in costs demands a higher win rate, and that increase (6 percentage points) is hard to sustain.

In R terms, the cost is 1.2 ÷ 8 = 0.15R per trade. With a 10,000 USD account risking 1% (100 USD), the lot size is 100 ÷ (8 × 10) = 1.25 lots and the spread costs 1.25 × 1.2 × 10 = 15 USD per trade. With 10 trades a day you pay 150 USD, that is 1.5R a day the strategy must make up before earning a single dollar of profit.

Costs by session and time of day

The effective cost changes through the day. In forex, the spread tends to be tighter during the London session and its overlap with New York, when liquidity is deeper, and wider in the Asian session for European pairs or around the daily close and open (the rollover), when it widens noticeably. It also widens in the minutes before and after macroeconomic releases.

This has a practical consequence: a scalping strategy that works at normal spreads can be unviable at the wrong time of day. Use our forex sessions tool to locate the most liquid windows, and check your broker’s real spread at different hours before deciding when to trade.

How to measure your real costs in the journal

For each trade, record the spread at entry, the commission paid, the planned price and the fill price (so you can compute slippage on entry and exit) and the accumulated swap. Then convert the total into multiples of R: cost ÷ planned risk. After 50 or 100 trades you will have a reliable average.

Compare the gross result (as if there were no costs) with the net result. If the difference exceeds a quarter of your average profit per trade, you have a cost problem: trade less, use wider stops, avoid bad hours or reconsider the instrument. Our journal tool lets you keep this data in your browser.

Common mistakes

Choosing a broker only for a spread “from 0.0” without adding the commission; backtesting without spread, commission or slippage; using the advertised average spread instead of the real spread at your trading hours; ignoring the swap on multi-day trades; and assuming the stop always fills at its exact price.

It is also common to increase trading frequency after a bad streak: more trades mean more accumulated costs, just when your expectancy is already under pressure.

Summary: what to do about costs

Express every cost in pips or dollars per trade and in multiples of R. Subtract the cost from winners and add it to losers before computing your real ratio and expectancy. Check that your strategy stays positive with a safety margin (for example, at double the average spread).

The shorter the stop and the higher the frequency, the more costs weigh. Measure spread, slippage and swap in your own journal, choose the most liquid hours and remember that trading leveraged CFDs carries a high risk of loss; this guide is educational and is not financial advice.

Educational content, not financial advice. Risk disclosure

Related tool

Forex market hoursLive session clock, forex market status, time converter, overlaps and best hours per pair in your own time zone.

More guides